2 x 960W @ 2ohms / 1920W @4 ohms bridged XP 2000
1920 Watt Power Amplifier
- Performance Indicators: Bridge/Parallel Modes, Three Signal and Clip/Limiter
- High-current toroidal transformers for greater 2 ohms power, lower noise and increased reliability and performance
- Balanced 1/4" TRS and XLR inputs; binding posts and SpeakonAR-type outputs
- Selectable high pass filters (30 Hz or 50 Hz) protect speakers and increase headroom
- Complete amplifier protection
21.800 Kg; ( 48.060 lb )
Phonic XP Series power amplifiers deliver from 280 to 5000 Watts of power in two to three rack spaces. Built around robust and advanced toroidal transformers, they deliver clean power on demand. The advanced protection circuitry guards against short circuit and open circuit, and also protects against ultrasonic and RF interference. A high current power supply increases reliability and performance. Other features include center-detented gain controls, input peak limiter, selectable high pass filter, and fast recovery to ensure low distortion. The variable speed fans effectively cool the amp and protect against overheating. Input is through XLR or 1/4" connectors, while you can use SpeakonAR-type or binding post connectors for output. The XP 2100, 3100 and 5100 power amps have sub woofer outputs with a selectable low pass filter at 60, 90 or 120 Hz. Phonic XP Power Amplifiers are specially designed for professionals who value high power, audio clarity, reliability and lasting performance.
Features :
- Output power: 600W @ 4 Ohm, 960W @ 2 Ohm
- High continuous current output from robust toroidal transformer
- Switchable input peak limiter and selectable high pass filter (30Hz, 50Hz) to reduce distortion and protect speakers
- Front mounted detented gain controls for easy access
- Bridge mono and parallel mode LEDs
- Fast Recovery design for lower distortion if clipping occurs
- Very rugged housing
- Active balanced inputs for low noise
- Signal level at -40, -20, -10, protect and clip LED indicators to monitor performance
- Ground Lift switch to prevent humming
- Selectable stereo, parallel & bridge mono amp modes
- Two ventilation variable speed fans
- SpeakonAR-type connectors and 5-way binding posts speaker outputs
- XLR & 1/4" TRS connectors for maximum input flexibility
- Requires two standard rack units for mounting
Fits a standard 19" rack
Related Products :
- ESM 122 ( 12" 2-Way Floor Monitor )
- ES 122 ( 12" 2-Way Stage Speaker )
- Impression 12 ( 12" 2-Way FOH/Floor Monitor Speaker )
All our amplifiers come with built-in protection for short circuit, subsonic, overheating, radio frequency interference, output DC offset and even AC power transformer fuses in case the amplifier power cord gets plugged into the wrong voltage outlet. Peak limiters keep your speakers from being overdriven, while subsonic filters keep your woofers from being damaged.
| 
|
