2 x 200W at 4 ohms, 70 volt
ICON 300
300 Watt Contractor Power Amp
- Barrier strip connection determines output mode of 25V, 70V or 100V
- XLR and barrier strip inputs plus XLR link outputs
- Automatic dual-speed, high efficiency fan cooling
- Simultaneously utilize low impedance outputs
- Toroidal output transformers provide full electrical isolation
- Built-in 45Hz subsonic filter - prevents speaker transformer saturation with minimal effect on program material
20.200 Kg; ( 44.533 lb )
ICON Series power amplifiers are designed with the needs of sound contractors in mind. The binding post outputs allow for connection to standard low impedance speakers. Barrier strip outputs enable 25V, 70V and 100V Line operation. Each amplifier channel has a separate toroidal secondary transformer that provides full electrical isolation and ensures maximum audio separation. Features like power up muting, full short-circuit temperature, DC offset protection and a built-in 45 Hz subsonic filter, combine to make the Icon Series an attractive, cost effective solution for any audio installation.
Features :
- Output power: 2 x 150W @ 70V or 100V
- Barrier strip connection determines output mode: 25V, 70V, 100V and low impedance outputs available simultaneously
- Automatic dual-speed, high-efficiency cooling fan
- Rear panel detented gain controls
- Stereo, bridge, or parallel operating modes
- XLR and barrier strip inputs
- XLR inputs and outputs for easy signal pass through in multi-amp setups
- Full short-circuit, temperature and DC offset protection
- Toroidal output transformers provide full electrical isolation and meet worldwide safety standards
- Built-in 45 Hz subsonic filter prevents speaker transformer saturation with minimal effect on program material
Related Products :
All our amplifiers come with built-in protection for short circuit, subsonic, overheating, radio frequency interference, output DC offset and even AC power transformer fuses in case the amplifier power cord gets plugged into the wrong voltage outlet. Peak limiters keep your speakers from being overdriven, while subsonic filters keep your woofers from being damaged.
| 
|
